Turn off the laser for 30 seconds and then restart the system. If the problem persists, contact GoLaser.ĭischarge Error – High voltage dump circuit test failed. Power Supply Charge – Turn off the laser for 30 seconds and then restart the system. If the problem persists, contact GoLaser. Power Supply Tolerance – Turn off the laser for 30 seconds and then restart the system. Power Supply Communication – Turn off the laser for 30 seconds and then restart the system.
It does not respond to actuation to the correct state. Shutter – The shutter is not in the correct state when checked. If the problem persists, contact GoLaser.Ĭanister Bubble Circuit – The canister bubble circuit test did not detect a change in the signal. Handpiece Bubble Circuit – Handpiece bubble circuit test did not detect a change in the signal. Allow 10 minutes to cool, then select the purge button and try again. Select the purge button to ensure the flow of cryogen from the handpiece. – If the canister is full, remove it and then reinstall it. – Check the canister level to see if it is empty. – Press and hold the purge button to purge bubbles out of the cryogen line. The Cryogen canister is empty, or lines are obstructed. Bubbles need to be purged out of the cryogen fluid lines. Problem: Bubbles are detected in the handpiece. – Disconnect fiber cable from the laser system and reinstall. – Reinstall the slider attachment and calibrate the laser system.įiber is not detected while in the Ready state. The slider attachment is removed while in the Ready state. – Disconnect and reinstall the electrical cable of the delivery system. The delivery system is disconnected while in the Ready state.
0 kommentar(er)
